How does a catalytic lamp work?

ON

ON

  1. The first step is to prepare a suitable place for the lamp, which should be resistant to stains and high temperatures, and provide enough space to avoid the danger of the flame that will appear after lighting the flame of the lamp.
  2. To place the liquid with the selected fragrance into the lamp container, remove the decorative cap, extinguisher (extinguishing cap) and gently remove the burner with the wick. Then, using the funnel, fill the lamp with the selected Scent Therapy fragrance liquid to about 2/3 of its volume. Le­aving space between the surface of the liquid and the neck of the container will allow air to circulate and start the catalytic process.
  3. Attention! If you add too much liquid and it overflows from the neck of the lamp, dry all components and reduce the amount of refill to the recommended volume.
  4. Place the catalytic burner (stone with a cotton wick) in the neck of the lamp and put the extinguisher on it. Leave the lamp for about 20-30 minutes for the wick to become satura­ted with the fragrance liquid. The extinguisher prevents pre­mature evaporation of the aroma.
  5. After this time, remove the extinguisher and set fire to the stone. Stone heating time is about 2-3 minutes. Attention! Remember that the flame can reach a height of up to 15 cm. Make sure the space above the lamp is clear and prepared for this possibility.
  6. After this time, extinguish the flame of the lamp by care­fully blowing out the flame. Attention! The stone will continue to stay hot throughout the process. Do not touch it or move the lamp.
  7. Carefully put the decorative cap on the lamp. Attention! The lamp is already very hot.
  8. After extinguishing the flame, the process of air purifica­tion, reduction of mites, mold, bacteria and release of fra­grance begins. Leave the lamp in this state for a maximum of 30 minutes (maximum suggested time for a room with an area of 14/16 m2). The fragrance release time for a 500 ml bot­tle is approximately 20 hours
OFF

OFF

1 and 2. After 30 minutes or less, remove the decorative cap and cover the stone (lamp) with an extinguisher. This will stop the catalytic process and protect the fragrance oil from eva­porating when the lamp is not in use. IMPORTANT! Do not touch or move the lamp for 30 minutes after it has cooled down.
3. Put the decorative cap on the extinguisher. ATTENTION! Remember not to put out the flame with a decorative cap or extinguisher at any stage of using the lamp. Always blow out the flame carefully.